This is a 4-channel analog mixer with 2 sends per channel. This allows you to route audio to effects modules. Then you can feed those effect outputs via 2 available return inputs and mix them with the dry audio.
It also comes with a diode-based distortion with 2 separate distortion circuits.
Inputs
- 1 Audio input for channel 1
- 2 Audio input for channel 2
- 3 Audio input for channel 3
- 4 Audio input for channel 4
- NC Not connected
- M Master input for daisy chaining another mixer
- SA Send A input for daisy chaining another mixer
- SB Send B input for daisy chaining another mixer
Outputs
- MIXOUT Mixed audio output
- OD_C Clean output from the overdrive
- OD_D Dirty output from the overdrive
- SEND_A Summed Send A output
- SEND_B Summed Send B output
- NC Not connected
- RETURN_A Return A input
- RETURN_B Return B input
Additional Parts
This section is only relevant if you are buying the semi-assembled module. You have to source & solder the following parts. You can check our guide on common parts for where to source these components.
- 2.54mm Header Pins (5-pin) - 4
- Circular Pin Header Sockets (5-pin) - 2
- 50K Potentiometers - 8
- 500K Potentiometers - 9