This is a MIDI-controllable analog hi-hat module. You can also control the hi-hat via GATE & CV signals.
You need to feed noise into the module to make it work. You may use our Noise module.
Features
- Open & Close Hi-Hat
- Accent Control
- Full MIDI Control
- Feed Custom Noise Sources
- Get the HiHat Envelope as CV
Inputs
- MIDI MIDI input to control the hi-hat generator
- NOISE External noise (audio) input
- GATE Gate input for triggering the hi-hat
- ACCENT CV input for accent control
- OPEN Gate input for open hi-hat
Outputs
- MIDI MIDI THRU (passthrough) output
- AUDIO Hi-hat audio output
- AUDIO Hi-hat audio output
- CV Envelope CV of the hi-hat
- CV Envelope CV of the hi-hat
Controls
- CUTOFF: Controls the cutoff frequency of the hi-hat. Left is higher frequency, right is lower.
- DECAY: Increases the decay of the hi-hat.
MIDI
- Use any note up to (and including) Middle C (C4) to trigger the hi-hat
- Any note above Middle C will open the hi-hat
- The velocity of the note will affect the DECAY control
Additional Parts
This section is only relevant if you are buying the semi-assembled module. You have to source & solder the following parts. You can check our guide on common parts for where to source these components.
- 2.54mm Header Pins (5-pin) - 2
- Circular Pin Header Sockets (5-pin) - 2
- 50K Potentiometers - 2
- Vactrols - 2