This is an analog waveform generator with configurable frequency ranges.
Functionality
- Select the frequency by connecting a column of two-pin sockets in the middle
- Define the maximum frequency it can generate by connecting a column of two-pin sockets at the bottom
- Better suited for LFOs
Outputs
- SQR Square Wave Output
- SQR Square Wave Output
- TRI Triangle Wave Output
- TRI Triangle Wave Output
- SIN Sine Wave Output (approximate)
Controls
- FREQ: Acts as the cutoff frequency of the low-pass filter
- FINE: Fine-tunes the above-mentioned frequency
Additional Parts
This section is only relevant if you are buying the semi-assembled module. You have to source & solder the following parts. You can check our guide on common parts for where to source these components.
- 2.54mm Header Pins (5-pin) - 2
- Circular Pin Header Sockets (5-pin) - 4
- 50K Potentiometers - 1 (FINE)
- 1M Potentiometers - 1 (FREQ)